May be located up to 100 feet (30 m) from batteries. 

Connect with four AWG 22 (.644 mm2) wires. Up to 300 feet (90 m) with AWG 18 (.823 mm2) wire. Longer distances are possible with larger wire size.

Choice of two shunts for use with TriMetric battery Monitor: 

Choose one of the following shunts for making the “Amps” and Amp-hour measurement as shown in photo below. 

• 500Amp-50 mV shunt: 

For systems with maximum current 400 Amps continuous with no overloads, or 300 Amps continuous with up to 5 minute overloads to 500 Amps max. It allows Amps readings as low as 0.1 amps. Suitable for most systems with moderate or large sized inverters. Size 3-1/4 by 1-3/4 inch base, 1-7/8 in high. (8.3 x 4.4 x 4.75 cm)

 • 100 Amp-100 mV shunt:

For systems with maximum current 70 Amps continuous with no overloads, or 50 Amps continuous with overload to 100 Amps for 8 seconds max. Suitable for small systems, or for most applications where you want to measure only solar or wind input current. It allows “Amps” readings as low as 0.01 amps. 

Cable for connecting meter to shunt:  

#22 gauge 4 wire twisted pair. 35 foot or 50 foot (10.5 m or 15 m) versions. With 3 small ring